مورد Ditec وتركيب وإصلاح في أبوظبي

Start with the sensor above the door: wipe the lens, check it has not been knocked out of position and look for new signage or decoration that blocks its view. Then check whether the door is stuck in a locked or night mode on its selector switch. If both are fine, the fault may be a failed sensor, a loose cable or a control unit that has lost its learned travel. A door that opens on a manual push but not on detection almost always points to the sensor or its wiring.

An operator that stops short is reading its limits in the wrong place or sensing resistance. Causes include a changed door balance after a spring change, a worn drive part that slips, a limit switch or encoder that has moved, or something resting on the door track. We run the door by hand first, then reset the travel and force and test the safety reversal. If the operator has a memory fault, a control board may need replacing, and we will tell you before work begins.

We inspect cables, drums, springs, rollers and panels, then test the operator, brake, limit switches and the safety edge or photocells. High-traffic doors are checked for loose fixings and worn hinges, which cause noise and misalignment. The control unit is inspected for dust and moisture, and the emergency release and manual operation are tested. Warehouses that run many cycles each day benefit from regular visits because small wear becomes a breakdown under heavy use.

Try the battery first and test a second handset if you have one. If the second handset works, the first is faulty or has lost its memory. If none work, the receiver may have failed, lost its memory or lost power, or its aerial may be damaged. We test the handsets and receiver on site and replace what is faulty. Please do not buy a random handset online, as radio types differ and compatibility has to be confirmed against your receiver.

Send us a WhatsApp message or use the quote form with your location and the door or gate type. We will then arrange a site visit to measure and advise.

Include the area, such as Al Khalidiyah, Saadiyat Island or Al Reem Island, plus photos and approximate dimensions if you have them. During the visit we check structure, power and access, then follow with a written quotation. You can also call +971 50 494 8667. Browse our gates and automatic doors first.

Yes, we provide annual maintenance contracts in Abu Dhabi for automatic doors, gates, shutters and barriers. Plans cover scheduled inspections, sensor calibration, lubrication and priority breakdown support.

A contract suits shops in Al Khalidiyah and Al Nahyan, apartment buildings in Saadiyat Island and warehouses in the industrial areas, where downtime costs money. Tell us what you have installed and how heavily it is used, and we will propose a plan. See our automatic doors and rolling shutters.

Yes, a site survey is strongly recommended before installation. It checks dimensions, structure, headroom, power, drainage and access so the right model is quoted and surprises are avoided.

Qasar Al Neil Automatic Doors can visit your site in Abu Dhabi to confirm details. Photos and measurements help, but a visit catches issues such as uneven ground or weak posts. The survey also lets us recommend safety devices and access control. Contact us to arrange one for your gate or door.

Most residential operators run on a 230 V single-phase supply on a dedicated, protected circuit, while heavy industrial units use 380 to 415 V three-phase. Low-voltage 24 V operators are common for added safety.

Cable size, distance from the mains and earthing all matter, and a qualified electrician should complete the supply. Solar or battery backup is an option where mains is far away. We confirm power needs during the survey for your gate or garage door.