مورد Dahua وتركيب وإصلاح في أبوظبي

Often yes. HDCVI is designed to carry higher resolution video over existing coax, so a site with analogue cameras can sometimes upgrade cameras and the recorder without new cabling. The condition of the cable matters: corroded ends, long runs and poor joints can limit picture quality. We test each run and replace connectors or damaged sections where needed. Where a cable is too poor to reuse, a new run or a move to IP cameras is the better choice.

Repeated restarts usually point to power or heat. A weak or failing power adapter, a recorder packed in a hot cabinet with no airflow, or a failing hard disk can all cause it. Dust inside the unit and a swollen internal power part are also common in older recorders. A technician checks the adapter output, cleans the unit, tests the disk and moves it to better ventilation if needed. If the main board is at fault, replacement is usually the sensible route.

PTZ cameras have moving motors and cables, so they wear faster than fixed units. A camera that will not move may have a worn motor, a stiff or corroded mechanism, a poor control connection or low power. Dirt and moisture inside the housing also cause stalling. We check power at the camera, test movement and presets, and open the housing if safe to do so. Some units can be repaired on site, others are replaced.

A white or washed-out night image is often infrared light bouncing off something close to the camera, such as a wall, a bracket or a spider web on the dome. Condensation inside the housing and a dirty lens also blur the picture. Check for webs and grime first, then look at how near the camera is to a surface. We clean the unit, adjust the angle or mounting and review the exposure settings on site where the camera allows it.

The technician cleans lenses and housings, checks mounts and cable glands, and views each camera on the recorder. Time and date are checked, recorded footage is played back and the hard disk health is reviewed. Power supplies, switches and any UPS are tested. If a camera or channel has failed, the fault is traced and a repair is proposed. You receive a short list of what was found and what needs attention.

It should. A correct installation links the barrier to the fire alarm panel, so the leaves open and stay open when the alarm sounds. This is a safety requirement for lobbies where people need to leave quickly.

Qasar Al Neil Automatic Doors tests this connection during commissioning and during every service.

A correctly installed turnstile is fail-safe. In a power cut or on a fire alarm signal, the arms or flaps release so people can walk out. Some models drop the arms, others unlock the rotor.

Qasar Al Neil Automatic Doors tests this release at handover and during servicing.

A swing barrier suits lobbies that need a welcoming look and easy access for wheelchairs, trolleys and luggage. A turnstile physically restricts one person at a time and suits sites where tailgating is a bigger concern. Some buildings use both: a turnstile for staff and a swing barrier for the accessible lane.